Case H40 - Drive Belt Installation; Final Belt Tension Check; Pre-Operation Review

these r
644 tral
Lonrer 1
is mom
If mom
loader,
TWO bel& are packL%&. vhth'Model H
44" and H46, 48" mmdwers. If mount
on Model 22
tse,fhe shorter
;t be used when
ted on a Mode1442 or 444 tract
ting'the mower on the 646 wh
drive belt, part number C13:
. rn
This belt is not inclut
with the
a,, w:,
0, 222
belt. 1
the mol;
Ire& -.
mower
Ter out
the hoo~
-- A
0 r.
eel
184
. .
9. Lee reUreS 17 and 18.' PulI trc ablar
ment drive lel to #e 1
sition. Raise 1 d and remove
spark plug wire as a safety precaution,
lnsert the drive belt in front of the idler
pulIeys, between the fan and heat ex-
changer and onto the attachment drive
clutch pulley. Turn the adjusting crank
clockwise until the belt can be easily
placed around the idler pulleys and onto
the mower drive pulley.
; proper
.. &LA *
e belt is
r. Tur
) make sure thr
ecated in each pullej 11 ~11; d
usting crank counterclockwise to 'te
ion-the belt until the two idler pule
ome into alignment. - Sush the attac
nent dr!
id reco
iue lev€
snnect tl
the ''off
; plug w
" psiti
ire.
/ffp (f Before operating the
mower, review and follow
the recommendations out-
lined in the Adjustments
and Maintenance section of
this manu-1
1
NQt, The J I Case COI
es
. the right to make lmpr wvernen- in
design or changes in specifications
at any time without incurring any
obligations to install them on units
previously sold.