Case H40 - Installation; Component Check and Preparation; Lift Link Identification

n a lev
and re
A. locate the tractor o el surface.
Check tires for equal
commended
.F.
pressures as outlined on page 7 of the
tractor operatc
B. Befare hsWK ult: IIIUWW, lay out and
check the individual compenents. The
Model K44 or H46, 44" or 48" mower
is ilIustrated En Figure 13 and includes
an extra drive belt and lift links to per-
mit their installation on either high or
low clearance tractors without separate
mounting kits. Since the Model H40,
38'"mower is only intended for the
Model 2210 or 222 tractors, it does not
include the extra belt or links.
abc
thr
the
ins
#OI
yre f 3 illustrates the Model H44
wer, serial number C30848 and
we and the H46 mower, seriar
number D30733 and abov 3121
H44 and H46 mowers, pril !se
serial 'numbers are shi
. .
ith
ee instead of four lift links and
long lj
re two short slots
tead of I [ slot.
nks ha7
one loq
e. Mot
3r tothe
wed .. . w
C. The following installatioi~ at.qut.~lct: la the
same whether the tractor is equipped
with hydraulic or mechanical lift,
MOWER DECK ASSEMBLY
L lFf t IN KS FOR 220,
NOTE:
ALL FOUR LIFT LlNKS ARE PACKAGED LOOSE.
ILLUSTRATION SHOWS THE LONGER LlN KS INSTALLED
FOR MOUNTlUG ON MODEL 442 AND 444 TRACTORS.
Figure 13.