Case Valentine - Valentine Bed Assembly Guide; Connecting Headboard to Side Rails; Assembling Foot End and Side Rails; Installing Bed Slats and Support Bars

Assembly Instructions
A x 1
B x 4
C x 4
D x 2
F x 1
L x 4
M x 12
N x 4
G x 2
J x 2
K x 2
H x 2
I x 2
Ex3
J
B+C
Insert bolts (K) outer and (G) inner, into the back of the headboard.
Insert dowels (E) into the front of the headboard and offer up to the corresponding side rail.
Push together and fully tighten using the spanner (A) and ttings (B+C) on bolt (G) inner.
Using Allen key (F) and threaded washer (J), fully tighten onto bolt (K) outer.
Insert threaded rod (D) and pin (I) as per the diagram and insert dowels (E)
into the remaining holes in the foot end.
Insert barrel cam (H) into the underside of the side rail.
Push the foot end and side rail together and fully tighten using spanner (A)
and ttings (B+C) with threaded rod (D) and a athead screwdriver (not supplied)
with barrel cam (H) and pin (I).
Attached brackets (L)
using a crosshead
screwdriver.
(Not supplied) with
screws (M).
Rest the crossbars in
place on the brackets
and attached using
screw (N).
The slats rest on top
bowing upwards.
2
1
J
B
C
Ex3
K
G
Ex3
D
I
C
B
H
3
Mx3
N
E x 12