Casio 3481 User Manual

Changing Display
Information During Run
Timing
One of three screens can be displayed during
run timing (Training Mode), and you can
specify the items you want to appear on each
screen.
This means you can configure a screen with
the items you want to monitor and display that
screen while you train.
l
Specifying the Screen to be Displayed
During Running (RUN FACE)
You can navigate between display screens by
pressing (A).
Example:
Setting Up Alerts
You can specify calories burned and elapsed
time target values for training. Then, the watch
will perform a sound and/or vibration operation
whenever a target value is reached while you
are training.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Press (C).
This displays the Training Mode screen.
3. Hold down (A) for at least two seconds.
This displays the Training Mode setting
screen.
Pointer
4. Use (A) and (D) to move the pointer to
[ALERT].
5. Press (C).
6. Use (A) and (D) to select the item whose
setting you want to change.
[CALORIES] Calories burned
[TIME 1] Time 1
[TIME 2] Time 2
7. Press (C).
8. Use (A) and (D) to select an alert setting.
[OFF] Disabled
[ON (REPEAT)] Enabled (repeat)
[ON (1 TIME)] Enabled (one time)
●
While [ON (REPEAT)] is selected, an
alert operation is performed whenever
a target value is reached.
9. Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the alert setting
screen will re-appear.
●
If you want to configure settings for
another item, repeat steps 6 through 9.
10. Press (E) twice to exit the setting screen.
Important!
●
To specify the alert interval for each
item, use G-SHOCK MOVE. Note that
you cannot configure settings using
watch operations.
Note
●
You can also use G-SHOCK MOVE to
enable or disable alerts.
Specifying the Distance Unit
Important!
●
When Tokyo (TOKYO) is the Home
City, the distance unit is fixed as
kilometers (km) and cannot be
changed.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
This displays the Timekeeping Mode
setting screen.
Pointer
3. Use (A) and (D) to move the pointer to
[UNIT].
4. Press (C).
5. Use (A) and (D) to move the pointer to
[DISTANCE].
6. Press (C).
7. Use (A) and (D) to select a distance unit.
[KILOMETER] Kilometers
[MILE] Miles
8. Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the unit setting
screen will re-appear.
9. Press (E) twice to exit the setting screen.
Note
●
You can also use G-SHOCK MOVE to
change the distance unit.
Operation Guide 3481
14

Casio 3481 Specifications

General

Brand	Casio
Model	3481
Category	Watch
Language	English