Operation Guide 3503
EN-16
Battery:
CR1616 x 1 (battery sold separately)
Battery life: Approximately 3 years
Conditions:
– Alarm: Once (20 seconds)/day
– Illumination: Once (1.5 seconds)/day
Specifications are subject to change without notice.
EN-15
Specifications
Accuracy:
±30 seconds per month average.
Basic Functions:
Hour, minute, second, month, day, day of the week, a.m./p.m.(P)
Auto-calendar set at 28 days for February
Alarm:
Setting units: Hour, minute
Beeper: 20 seconds
Hourly time signal: Watch beeps every hour on the hour.
Stopwatch:
Measuring units: 1/10 second
Measuring capacity: 59 minutes, 59.9 seconds (60 minutes)
Other:
LED light
EN-14
Main Indicators
Number Name See
1
PM indicator EN-8
2
Stopwatch Mode EN-13
3
Alarm on indicator EN-11
4
Hourly time signal on indicator EN-11
1342
EN-13
Stopwatch
The Stopwatch Mode lets you measure elapsed time. The
range of the stopwatch is 59 minutes, 59.9 seconds.
To measure elapsed time
D
D D D A
Start Stop Resume Stop Reset
Minutes: Seconds
1/10 second
EN-12
To test the alarm
Hold down D while in the Alarm Mode to sound the alarm.
EN-11
2. Press D to increase the flashing digits.
x Holding down D changes the setting at high speed.
x Press C to return to the Timekeeping Mode.
To stop the alarm
Press any button to stop the alarm after it starts to sound.
To enable and disable the Daily Alarm and Hourly Time Signal
Press D while in the Alarm Mode to change the settings of the Daily Alarm and
Hourly Time Signal in the following sequence.
Both enabled Both disabled Daily Alarm only Hourly Time
Signal only
DDDD
EN-10
Alarm
When the Daily Alarm is turned on, the alarm sounds for 20 seconds at the preset
time each day. When the Hourly Time Signal is turned on, the watch beeps every
hour on the hour.
x The watch returns to the Timekeeping Mode automatically if you do not perform
any button operation for one or two minutes in the Alarm Mode.
To set the alarm time
1. In the Alarm Mode, press A.
Hour setting
AA
Minute setting
Normal Alarm Mode
(No flashing)