— 18 —
1 Use Program 4 to read the assignment of functions to programmable keys and then make
changes.
2 Use Program 3 to read the definition of machine features and key functions and then make
changes.
3 Use Program 1 to read programming of time, date and unit price, amounts, rates, etc. and then
make changes.
10-2. Using the worksheets
The worksheets included in this manual for Program 3 and Program 1 help to make your
programming simple and accurate. We recommend that you fill out the pertinent worksheet before
attempting actual programming.
1) Carefully read each definition and specify a selection.
Each definition is following by a Specification column which contains numeric values(Usually to
indicate a simple YES or NO answer). Determine the correct value according to your need and
enter it in the Selection column to the right.
2) Total each set of selections to calculate each program code digit.
Three selections(a,b,c) make up a set. Add up each set of selections and fill in the totals in the
Program code column for data items D8 through D1.
3) Program the feature or function.
Be sure that you have filled in all of the selections and program code digits for the entire worksheet,
and follow the procedure noted for the feature or function you are programming.
4) Check the printed program receipt against the worksheet.
Perform program read operation in each program mode to print setting which you have
programmed, to check then against the worksheet. We recommend that you do so and keep a copy
on record to help out should it become necessary for you to change the program.
10-3. Clearing a machine lock up
If you make a mistake in operation, the cash register may lock up to avoid damage to programs and
preset data. Should this happen, you can use the following procedure to clear the lock-up without
losing any memory data.
• Procedure
Set the Mode switch off.
While holding down the Key, set the mode switch
to X1.
Release the key.
You should see “FFFFFFFFFF” on the display. If 10 of F’s are
not shown on the display or if another character is shown,
immediately set the mode switch to OFF and start from the
beginning of this procedure. IF you don’t see “ FFFFFFFFFF”
on the display, do not press the
key.
Finalize the procedure.
RECEIPT
FEED
RECEIPT
FEED
Sub
Total
Off
Press receipt
feed key
Off
Press receipt
feed key
To Next Page
Loading...
Need help?
General
