239
Manipulating List Data 17 - 3
Example To input the number sequence 1
2
, 6
2
, 11
2
into a list
Use the following settings.
Variable: x Ending value: 11
Starting value: 1 Pitch: 5
AK1(LIST)5(Seq)v
x,v,b,bb,f)w
Specifying an ending value of 12, 13, 14, or 15 produces the same result as
shown above since they are less than the value produced by the next increment
(16).
uu
uu
uTo find the minimum value in a list [OPTN]-[LIST]-[Min]
K1(LIST)6(g)1(Min)6(g)6(g)1(List) <list number 1-6>
)w
Example To find the minimum value in List 1 (36, 16, 58, 46, 56)
AK1(LIST)6(g)1(Min)
6(g)6(g)1(List)b)w
uu
uu
uTo find the maximum value in a list [OPTN]-[LIST]-[Max]
Use the same procedure as when finding the minimum value (Min), except press
2 (Max) in place of 1 (Min).
uu
uu
uTo find which of two lists contains the smallest value
[OPTN]-[LIST]-[Min]
K1(LIST)6(g)1(Min)6(g)6(g)1 (List) <list number 1-6>
,1 (List) <list number 1-6> )w
• The two lists must contain the same number of data items. Otherwise, an error
occurs.
• The result of this operation is stored in ListAns Memory.
Example To find whether List 1 (75, 16, 98, 46, 56) or List 2 (35, 89, 58, 72,
67) contains the smallest value
K1(LIST)6(g)1(Min)
6(g)6(g)1(List)b,
1(List)c)w
To Next Page
Loading...
Need help?
General
