Casio CT-X5000

Using the MIDI Recorder to Record
EN-100
1. Perform the procedure under “To enter the
Song Editing Mode” (page EN-99).
2. Press the [6] (ENTER) bm number key.
This displays “Clear”.
3. Use the [1] (V) and [3] (W) bm number keys
to display “Copy”, and then press [6] (ENTER).
This displays “Point A”.
4. Use bn [–] and [+], or the bl dial to select the
number of the first measure of the range you
want to copy, and then press [6] (ENTER).
This displays “Point B”.
5. Use bn [–] and [+], or the bl dial to select the
number of the last measure of the range you
want to copy, and then press [6] (ENTER).
This displays “DstPoint”.
6. Use bn [–] and [+], or the bl dial to select the
number of the first measure of the copy
destination, and then press [6] (ENTER).
This displays “Sure?”
7. Perform the procedure under “To exit the Song
Editing Mode operation” (page EN-99).
1. Perform the procedure under “To enter the
Song Editing Mode” (page EN-99).
2. Press the [6] (ENTER) bm number key.
This displays “Clear”.
3. Use the [1] (V) and [3] (W) bm number keys
to display “Insert”, and then press [6] (ENTER).
This displays “Point”.
4. Use bn [–] and [+], or the bl dial to select the
measure from which you want to insert blank
measures, and then press [6] (ENTER).
This displays “Length”.
5. Use bn [–] and [+], or the bl dial to specify the
number of blank measures you want to insert,
and then press [6] (ENTER).
This displays “Sure?”
6. Perform the procedure under “To exit the Song
Editing Mode operation” (page EN-99).
To copy an entire song in measure units and
insert them into a specified location of the
same song
To insert blank measures at a specified
location in a song
CTX5000_3000_EN.book 100 ページ ２０１８年２月２６日 月曜日 午後３時５６分