Controlling the Keyboard Sounds
E-14
■ Short Sampling
With short sampling, you can sample up to three sounds,
each one with a duration of approximately 0.3 seconds. You
can sound the short sampled sounds using voice pads
1 through 3.
1.
Connect an external device to the Digital
Keyboard.
Refer to steps 1 through 2 under “Full Sampling” (page
E-13).
2.
While holding down
4
, press the voice pad
(
br
,
bs
, or
bt
) that corresponds to the tone
number where you want to store the sound.
• The relationship between tone numbers and voice pads
is shown below.
Example: When voice pad 3 (Tone Number 404) is
selected
Record standby is entered when you release
4
.
3.
Output the sound from the external device.
Sampling starts automatically and stops after about 0.3
seconds.
• Sampling will not start if the volume level of the external
device is too low.
4.
Try playing something on the keyboard.
• You also can sound the sampled sound by pressing the
voice pad you pressed in step 2.
• Sampling a new sound deletes the sound assigned to the
same tone number and the full sampling sound (page
E-13).
Selected Tone
Number
402 403 404
Pressed Voice Pad
Pad 1
(
br
)
Pad 2
(
bs
)
Pad 3
(
bt
)
Vo i .Pad3
Flashes
W
aiting
Flashes
Vo i .Pad3
Lights
To Next Page
Loading...
Need help?
General
