Casio CTK-6250 User Manual

Using the Song Sequencer
E-73
1. Press the C-3 (SONG SEQUENCER) button to
enter the song sequencer mode.
2. Use the dial or R-14 (–, +) buttons to select a
song area number.
3. Press the C-5 (MIXER) button to display the
mixer screen.
4. Use the R-17 (u, i) buttons to select the part
you want to play (A04 through A16, B01 through
B16).
• For example, to play only the melody that was recorded
using the UPPER 1 part and recorded into the system
track, select Part A05. For details about the content of
each part, see “How Parts are Organized” (page E-38).
5. Use the R-17 (t, y) buttons to move the thick
brackets (%) to “Part”.
6. Press the R-14 (–, +) buttons at the same time.
• This causes the setting to change to “Sol” (Solo).
7. Press the L-16 (START/STOP) button.
• This starts playback only of the part you selected in
step 4.
• Playback stops automatically when it reaches the end
of a song. To stop playback part way through, press the
L-16 (START/STOP) button.
1. Hold down the L-12 (REPEAT) button until the
locator screen shown below appears on the
display.
2. Specify a measure as the start point of the
phrase to be repeat played.
3. Specify a measure as the end point of the
phrase to be repeat played.
4. Press the R-16 (ENTER) button.
• This causes the cursor to stop flashing.
5. Press the R-15 (EXIT) button to exit the locator
screen.
6. Perform the following steps to start phrase
repeat play.
To play back a particular part alone
To repeat play a specific phrase
(1) Press the R-14 (+) button.
This will input “001:01:00” into the start point input area
(A), and cause the cursor to start to flash.
(2) Use the dial or R-14 (–, +) buttons to specify the start
measure number.
(1) Press the R-17 (i) three times to move the cursor to
the end point input area.
Press the R-14 (+) button.
The end point input area (B) initially shows the
measure that is one measure after the start point.
(2) Use the dial or R-14 (–, +) buttons to specify the end
measure number.
(1) Press the L-12 (REPEAT) button.
This causes the ? indicator to appear on the
display.
(2) Press the L-16 (START/STOP) button.
The specified phrase plays back in a loop.
Start point input area End point input area
B
CTK6200_04_e.fm 73 ページ ２０１３年６月１７日 月曜日 午後３時２０分

Casio CTK-6250 Specifications

General

MIDI-keyboard number of keys	61 keys
Product color	Black, Red
Sound effects	Chorus, Equalization, Flanger/Digital Signal Processing (DSP), Reverberation
Volume control	Digital
Pitch bend wheel	Yes
Maximum polyphony (notes)	48
Interface	USB
USB ports quantity	1
Cables included	AC
Battery type	D
Number of batteries supported	6

Weight and Dimensions

Depth	384 mm
Width	948 mm
Height	122 mm
Weight	5700 g