— 24 —
<Other utilities>
■ Bender reset
Sets bender’s center point in initial value.
1. While pressing down “ENTER” and “ACCOMP CHORD MODE” buttons, turn the power on.
2. Display shows “BndReset” indicating that pitch bender’s center point is initialized.
3. Perform the “System reset” described below.
■ System reset
1. While pressing down “ENTER” button, turn power on.
2. Display indicates “Reset?”.
3. Pressing “+” button initializes the instrument.
Pressing “–” button invalidates system reset.
4. The instrument turns on automatically.
■ Touch off max
1. While pressing down “RHYTHM” and “ACCOMP CHORD MODE” buttons, turn the power on.
2. Display indicates “TouchMax”.
3. The instrument is set in touch off max mode.
In this state, sound volume in touch response off mode becomes maximum.
To Next Page
Loading...
