Using Drawbar Organ Tones
E-51
Use the sliders and buttons to adjust drawbar organ tones in
real time.
1.
Perform steps 1 through 3 of the procedure
under “To select and play with a drawbar organ
tone” (page E-50).
• The level meter shows the harmonic overtone levels for
the foot “lengths” preset for the currently selected
drawbar organ tone.
• You also could skip this step and start from step 2 of
this procedure, if you want.
2.
Hold down the R-12 (MANUAL) button until the
foot “length” values (16' through 1') along the
top of the level meter flash twice. You can
release the button at this time.
• This will cause the level meter to indicate the current
positions of sliders D-4 (16') through D-12 (1'), and
apply applicable harmonic overtone levels to the
current tone.
3.
Shift sliders D-4 (16') through D-12 (1') upwards
and downwards.
• When you do, the displayed harmonic overtone levels
will change accordingly in the level meter.
4.
Now you can play on the keyboard using the
level-adjusted tone.
Adjusting a Drawbar Organ Tone in Real
Time
To do this: Do this:
Adjust tone harmonic
overtone levels
Shift sliders D-4 (16') through D-12
(1') upwards and downwards.
• Shifting one of the sliders
upwards or downwards changes
the harmonic overtone of the
corresponding foot “length” from
its current level (the level preset
for the tone).
*1
• You also can configure the level
meter so it indicates the harmonic
overtone level of each slider
position. For more information,
see “To configure the level meter
to show the harmonic overtone
level of each slider position”
(page E-51).
Add or remove
percussion sound with
2nd overtone and 3rd
overtone pitch to a
tone
Use the D-2 (PERCUSSION
SECOND) and D-3 (PERCUSSION
THIRD) buttons.
• Each press toggles the button
between lit and unlit.
• The corresponding overtone
percussion is being applied to
notes while a button is lit, and not
being applied while it is unlit.
Switch the rotary
effect speed (rotation
speed)
*2
Press the D-1 (ROTARY SLOW/
FAST) button.
• Each press toggles the button
between lit and unlit.
• Rotary speed is fast while the
button is lit and slow when it is
unlit.
*1 Adjustment to one of nine levels, from 0 to 8, is supported.
Each level is indicated by the level meter as shown below.
*2 This operation is supported only when DSP is being used
as the effect and the DSP type is “Rotary”. For details
about effects, see “Applying Effects to a Sound” (page
E-29). For details about DSP types, see “DSP Effect List”
(page E-155).
10 2345678
To configure the level meter to show the
harmonic overtone level of each slider
position
CTK7300IN_e.book 51 ページ ２０１３年７月１９日 金曜日 午後１２時１分
To Next Page
Loading...
