Using the Song Sequencer
E-91
1.
Perform steps 1 to 3 of the procedure under “To start an event editor operation” on page E-87 to display
the event editor screen.
2.
While holding down the R-13 (FUNCTION) button, use the R-17 (u, i) buttons to select the track you
want to edit.
FTun Part Fine Tune [FinTune]
PART Part
HARM, UPP1, UPP2,
LOWR
VALU Part Fine Tune –99 - 00 - +99
BndR Part Bend Range [BendRng]
PART Part
HARM, UPP1, UPP2,
LOWR
VALU Part Bend Range 00 - 24
RSnd Part Reverb Send [RevSend]
PART Part
HARM, UPP1, UPP2,
LOWR
VALU Part Reverb Send 000 - 127
CSnd Part Chorus Send [ChoSend]
PART Part
HARM, UPP1, UPP2,
LOWR
VALU Part Chorus Send 000 - 127
DspL Part DSP Line [DspLine]
PART Part
HARM, UPP1, UPP2,
LOWR
VALU Part DSP Line on, oFF
AVol Accomp Volume
*5
[AcmpVol] VALU Accomp volume 000 - 127
AScl Accomp Scale
*6
[AcmpScl] VALU Accomp Scale on, oFF
OrgB Drawbar Organ Drawbar [OrgnBar]
PART Part
HARM, UPP1, UPP2,
LOWR
Ft. Feet
16, 5
1
/3, 8, 4, 2
2
/3, 2,
1
3
/5, 1
1
/3, 1
VALU Level 0 - 8
OrgP
Drawbar Organ
Percussion
[OrgnPrc]
PART Part
HARM, UPP1, UPP2,
LOWR
TYP Type 2nd, 3rd
VALU On/Off on, oFF
*1 A chord event is not displayed as the event name at position
2
, but rather as the chord root (C, etc.)
*2 See “Fingering Guide” on (page E-160).
*3 Intro: intro pattern, norml: normal pattern, Vari: variation pattern, nFlOn: normal fill-in on, nFloF: normal fill-in off,
vFlOn: variation fill-in on, vFloF: variation fill-in off, Endin: ending pattern.
*4 “C-” on the display indicates C-1 (one octave below C0).
*5 This setting corresponds to the function menu “AccompVol.” item (page E-133).
*6 For details, see “Specifying whether the Current Scale Settings Should be Applied to Auto Accompaniment (Accomp Scale)”
(page E-22).
To select a track for editing
Event Type
2
display during
insert
4
display Parameter Name Setting Range
2
display Event Name
CTK7300IN_e.book 91 ページ ２０１３年７月１９日 金曜日 午後１２時１分
To Next Page
Loading...
