Using the Function Menu
E-101
■ To initialize all data and settings (or parameter
settings only)
1.
Press the R-13 (FUNCTION) button to display
the function menu.
2.
Use the R-17 (i, y) buttons to move the 0 to
“General” and then press the R-16 (ENTER)
button.
3.
Use the R-17 (i, y) buttons to move the 0 to
“Initialize” and then press the R-16 (ENTER)
button.
• This displays the initialize screen like the one shown
below.
4.
Use the R-17 (t, y) buttons to select either
“All” (all settings) or “Parameter” (parameter
settings only).
5.
To execute initialization, press the R-16
(ENTER) button.
CTK6000_e.book 101 ページ ２０１０年７月１２日 月曜日 午後１２時５０分
To Next Page
Loading...
Need help?
General
