Using the Mixer
E-43
The MIC/INST parameters include microphone input (input via T-7 (MIC IN) jack) related settings.
MIC/INST Parameters (WK-6500 Only)
Parameter Name Description Setting Range
Part
(Mic/Inst Enable)
Specifies if sound input via a microphone should be output (on) or not output
(oFF).
oFF, on
*
Volume
(Mic/Inst Volume)
Specifies the volume level of sound input via a microphone.
*1
0 to 127
*
Pan
(Mic/Inst Pan)
Specifies the stereo pan position of sound input via a microphone. 0 indicates
the center, while a smaller values shifts to the left and a larger value shifts to the
right.
–64 to 0
*
to +63
DSP Line
(Mic/Inst DSP Line)
Specifies whether DSP should be applied to microphone input. oFF, on
*
Rev.Send
(Mic/Inst Reverb Send)
Specifies how much reverb is applied to sound input via a microphone. 0 to 40
*
to 127
Cho.Send
(Mic/Inst Chorus Send)
Specifies how much chorus effect is applied to sound input via a microphone. 0
*
to 127
*1 See the block diagram under “Configuration of Effects” (page E-32).
CTK6000_e.book 43 ページ ２０１０年７月１２日 月曜日 午後１２時５０分
To Next Page
Loading...
Need help?
General
