3
The lens cap opens and closes
automatically in accordance with the
lens position, so you can leave it in
place, if you want. Make sure the lens
cap is attached to the lens so the dot
mark on the cap is upwards, with the
large blades of the cap on the left and
right. If the cap is in the wrong position,
its blades can cause partial darkening
of images when shooting with flash.
• Attach either end of the strap to the two strap
rings on the sides of the camera as shown in the
illustration.
• After you are finished pull on the strap to test it
and to make sure it does not come loose.
. Adjusting the Length of the Strap
You can adjust the length of the strap so it can
be used as a neck strap or a shoulder strap.
1. Pull the strap out at the center
of the buckle in the direction
indicated by
1
.
2. Pull the strap in one of the
directions indicated by the
illustration to adjust the length.
Attaching and Removing the Lens Cap
Attaching the Neck Strap to the Camera
Attachment
Removal
Mark
Attach the lens cap with the large blades
on the left and right.
1
To shorten
To lengthen
To Next Page
Loading...
Need help?
General
