APPENDIX
112
Other
Symptom Possible Cause Action
All buttons and switches are
disabled.
Monitor screen is off.
Cannot transfer files over a
USB connection.
Circuit problem caused by electrostatic charge, im-
pact, etc. while the camera was connected to an-
other device.
1) “LCD-OFF” is selected for the “Indicators” setting
on the REC tab.
2) USB communication is in progress.
1) Camera is not set securely on the USB cradle.
2) USB cable is not connected securely.
3) USB driver is not installed.
4) Camera is turned off.
Remove the battery from the camera, reinsert it,
and then try again.
1) On the REC tab menu, change the “Indicators”
setting to “LCD-ON” (page 51).
2) After confirming that the computer is not access-
ing camera memory, disconnect the USB cable.
1) Check the connection between the camera and
USB cradle.
2) Check all connections.
3) Install the USB driver on your computer (page
81).
4) Turn on the camera.
To Next Page
Loading...
Need help?
General
