E-27
Note
• Executing a playback operation while the cursor is located within a calculation will cause the
cursor to move back to the nearest Memory Character before (to the left of) the current cursor
position (in order to determine the current Main Memory contents) and start playback from there.
• Each time playback comes to a Memory Character, the Main Memory contents that were stored
for that location are looked up, and playback then proceeds to the next operation using the looked
up contents.
• Current Main Memory contents are automatically backed up whenever you click
to start a
new Key-Log playback operation. This will allow you later to restore memory contents to what
they were before you started playback (if you want).
• Closing a Key-Log file causes the message shown below to appear. You can specify whether you
want Main Memory to be restored to the contents that were automatically backed up when you
started playback of the Key-Log file (see above).
• You can use the optional settings dialog box (page E-30) to configure playback settings like the
key playback interval following a pause, the color of playback keys, etc.
• Simultaneous playback of multiple Key-Log files is not supported. If you try to open a Key-Log file
while another Key-Log file is already open, the currently open file will close automatically. If the
currently open file has been edited, a message will appear asking if you want to save it before
closing.
To Next Page
Loading...
Need help?
General
