Example Memorizing the BASE-N mode in P2
iMODEll
W RT
400
P i l l S345B789
W RT
400
P 01ÎS3456789
B A S E — N w r t
400
P 01B3456789
Assuming that nothing
is stored.
Specify P2.
Specify the BASE-N
mode.
B A S E -N
W RT
0 0 0
-3 *
As shown above, the calculation mode will be memorized into a program area.
■Cautions concerning the calculation modes
All key operations available in each calculation mode can be stored as programs,
but, depending on the calculation mode, certain commands of functions cannot
be used.
BASE-N mode
•Function calculations cannot be performed.
•Units of angular measurement cannot be specified.
•All program commands can be used.
•Be sure to include a “ A ” at the final result output to return to the previous cal
culation mode when a program execution is terminated. Failure to do so may
result in a decimal display or an error.
SD1, SD2 mode
•Among the functions, Abs and V- cannot be used.
•Among the program commands, Dsz, > and < cannot be used.
LR1, LR2 mode
•Among the functions, Abs and cannot be used.
•Among the program commands, =», =, Isz, >, <, Dsz, > and < cannot
be used.
- 1 1 8 -
To Next Page
Loading...
