E H Erasing Programs
Erasing of programs is performed in the PCL mode. Press B S to specify the
pCL mode. There are two methods used to erase programs: erasing a program
located in a single program area, and erasing all programs.
■Erasing a single program
To erase a program in a single program area, specify the PCL mode and press
the IS key after specifying the program area.
Example Erase the program in P3 only.
W l3l
PCL
302
P ^.12_45678_
P0, P3 and P9 already
contain programs.
PCL
302
P _12^,45678_
Align cursor with P3.
PCL
345
P_12B45678_
Number 3 appears after
deletion.
SIT)
Return to RUN mode.
■Erasing all programs
To erase all programs stored in program areas 0 through 9, specify the PCL mode
and press S and then g .
Example Erase the programs stored in P0, P4, P8 and P9.
(MODElm
PCL
273
P ^123_567
__
PCL
400
P m 23456789
s e n
-1 1 9 -
To Next Page
Loading...
