Casio MT-640

Performance Memory Function
* Refer to the general guide found on page 4-5 for exact locations of this keyboard controls and
connections.
é The MT-640’s performance memory function lets you record an entire per-
. J ‘formance as you play on the keyboard. Up to 1,250 notes can be stored
in memory for subsequent playback. What’s more, auto-rhythm tracks and a
variety of keyboard settings: are recorded as well (see list below).
@) Start an auto-rhythm and adjust the tempo to your satisfaction.
(2) Press the record button to enter the recording standby mode (LED flashes).
* Note that you can also adjust the tempo in this mode. — | fi
(3) Set the Chord/MIDI selector to “FINGERED 1”, “FINGERED 2”, or “ON” if you
want to use auto-accompaniment in your recording. If not, set this selector
to the “OFF” position..- | |
() Select one of the auto-rhythms you like. .
* If you don’t want to use an auto-rhythm in your recording (or if you want to start an auto-rhythm
mid-way during recording), press the rhythm start/stop button at this point.
* If you want to start an auto-rhythm using an intro pattern, press the intro/ending button at this
point. |
* If you want to start an auto-rhythm using synchro start, press the synchro/fill-in button at this point.
(6) Press the recording start/stop button to start recording. Recording starts after
one measure of audible beat count. Lo | i
© Begin your performance. The MT-640 records your entire performance, just
the way you play it. 7
Recorded Operations: :
In addition to keyboard play, the performance memory records the following
keyboard settings and operations.
e Preset tones
e Tone bank selection
e Auto-rhythm selection
e Auto-rhythm start/stop
e Auto-rhythm intro start
e Fill-in patterns
e Percussion solo pad performance
e Auto-rhythm ending pattern
@) Press the recording start/stop button again to stop recording.
ey) om
10.
Performance
Memory
Function
NOTES:
°
Memory
capacity
is
approximately
1,250
notes.
Operations
such
as
changes
in
rhythms
and
Tone
Bank
sound
selections
are
counted
as
half-notes.
*
Recording
automatically
ends
when
you
reach.
the
memory
capacity.
@)
Press
the
recording
start/stop
button’
to
The
start/stop
LED
flashes
and
playback,
begins.
play
back
your
performance.
¢
You
can
play
along
with
memory
playback,using
the
entire
keyboard,
2
ici
.
deers
has
been
done
_in
the
Casio
Chord
“OFF”
mode.
If
you
record-
'
€d
using
the
Casio
Chord
function,
only
the
melody
k
pin
agg
iy
E
me
ody
keyboard
(upper
keys)
°
In
this
playback
Status,
all
switches
and
buttons
except
the
volume
sliders
and
6
of
the
percussion
pads
(hi
tom,
mid-tom,
low
tom,
crash
symbal,
hi
agogo
and
low
agogo)
are
inoperative.
Tempo
of
playback
cannot
be
adjusted.
@)
Press
the
recording
starU/stop
button
again
to
stop
playback.
(oe