Casio MTP4500D-1AV User Manual

Operation Guide 4755
1
MA0606-EA
Using the Stopwatch
The stopwatch lets you measure elapsed time up to 11 hours, 59 minutes, 59 seconds.
To measure times with the stopwatch
Elapsed Time
Start
Stop Re-start Stop
Clear
To adjust the positions of the stopwatch second hand
1. Press B to reset the stopwatch, and check the alignment of the stopwatch minute
hand and second hand.
2. Pull out the crown.
3. Press A to move the stopwatch second hand forward until it points to the 12
o’clock position.
4. Push the crown back in to its normal position.
••
••
• To set the time
1. Pull the crown out when the
second hand is at 12 o’clock
position and the second hand
stops.
2. Set the hands by rotating the
crown. Rotate the crown to
move the hands. Move the
minute hand four or five minutes
past the time you want to set,
and then back it up to the
proper setting.
3. Push the crown back in to the
normal position.
Stopwatch second hand
Stopwatch minute hand
Stopwatch hour hand
■ For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the
mark with the
minute hand.
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
• Some water resistant models are equipped with a screw lock
crown.
• With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
• Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
Elapsed time bezel
Minute hand Hour hand
Setting time
Crown
(Normal position)
Second hand
5
0
40
30
20
10

Casio MTP4500D-1AV Specifications

General

Brand	Casio
Model	MTP4500D-1AV
Category	Watch
Style	Casual
Case Material	Stainless Steel
Band Material	Stainless Steel
Movement	Quartz
Dial Color	Black
Case Diameter	42 mm
Band Width	20 mm
Features	Date Display
Water Resistance	50 meters
Crystal	Mineral
Clasp	Fold Over Clasp

Summary

Setting the Time

Pull out the crown

Pull the crown out when the second hand is at 12 o'clock position and the second hand stops.

Set the hands

Set the hands by rotating the crown, moving the minute hand past the desired time and back.

Return the crown

Push the crown back in to its normal position after setting.

Using the Stopwatch

Measuring Elapsed Time

The stopwatch measures elapsed time up to 11 hours, 59 minutes, 59 seconds.

Adjusting Stopwatch Second Hand

Instructions to reset the stopwatch and align second and minute hands to the 12 o'clock position.

Elapsed Time Bezel

How to use the elapsed time bezel by aligning the mark with the minute hand.

Screw Lock Crown

Handling screw lock crowns on water-resistant models for setting and security.