9
Part-1
9
E
Part-1 QUICK START OPERATION
QUICK START OPERATION
Part-1
1. Loading Memory Protection Battery
Important
You must initialize
the Cash register and
install the memory
protection batteries
before you can pro-
gram the cash regis-
ter.
1. Remove the printer cover.
2. Open the battery compartment cover.
3. Load 2 new SUM-3 ("AA") type batteries into the compartment.
Be sure that the plus (+) and minus (–) ends of each battery are
facing in the directions indicated by the illustrations inside the
battery compartment (Figure 1).
4. Replace the memory protection battery compartment cover
back into place.
REPLACE MEMORY PROTECTION BATTERIES AT LEAST
ONCE EVERY YEAR.
(Figure 1)
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
2. Loading Paper Roll
To load receipt paper
!
Open the platen arm.
@
Ensuring the paper is being fed from the bot-
tom of the roll, lower the roll into the space
behind the paper.
#
Put the leading end of the paper over the
printer.
$
Close the platen arm slowly until it locks
steadily.
To Next Page
Loading...
Need help?
General
