Digital Piano Operations
EN-24
■ To configure DSP settings
1.
Use the procedure under “To select a DSP”
(page EN-23) to select the DSP whose settings
you want to configure.
2.
Hold down bq DSP until “[DSP SETTING]”
appears on the display.
This enters the DSP setting mode and displays “DSP On/
Off”.
• “DSP On/Off” specifies whether or not a DSP should
be applied to a tone. After confirming that “On” is
selected for this setting, proceed to step 3. “DSP On/
Off” is always “On” if you selected a preset DSP in step
1 of this procedure.
• If you selected a default DSP (indicated by “Tone” on
the display), the default setting here is “Off”, which
means the DSP is not being applied. If this setting is
“Off”, touch bp EXIT to return to step 1 and select a
different tone and/or DSP. Or you can use the steps
below to change the “DSP On/Off” setting to “On”.
Selecting “On” here will make preset DSP 1 the target
of any setting changes you configure.
(1) After confirming that “DSP On/Off” is displayed,
touch bm ENTER.
(2) Use the bk – and bl + buttons to change the setting
to “On”.
(3) Touch bp EXIT.
3.
Use the bk U and bl I buttons to select a
DSP module and then touch bm ENTER.
This displays one of the parameters of the DSP module
you selected.
4.
Use the bk U and bl I buttons to display the
parameter whose setting you want to change
and then touch bm ENTER.
This enters the parameter editing mode.
5.
Use the bk – and bl + buttons to change the
parameter setting.
• To return to the initial default parameter setting, touch
bk – and bl + at the same time.
6.
When the setting is the value you want, touch
bp EXIT.
7.
Repeat steps 4 through 6 as required. When
the settings are the way you want, touch
bp EXIT.
This returns to the DSP module display in step 3 of this
procedure.
8.
Repeat steps 3 through 7 as required.
9.
To exit the DSP setting mode, touch bp EXIT.
[
DSP SETT I NG
]
<
DSP On / O f f
>
[
DSP SETT I NG
]
<
W
etLeve l
>
[
DSP SETT I NG
]
–
040
+
W
et Leve l
To Next Page
Loading...
Need help?
General
