Casio QW-3195 - Time Calibration Signal Test

– 9 –
TIME CALIBRATION SIGNAL TEST7-5.
A signal reception failure may be caused by a number of of reasons.
Follow the steps shown in the owchart below to run the signal receiving test.
YES
YES
NO
NO
MANUAL Reception
Failure
OK
Reception OK?
Reception OK?
Check the Receiving Station
START
AUTO Reception
"Insufficient Signal" may also be the reason
for the signal receiving fault.
Insufcient Signal
The time calibration signal may not be properly received under the following conditions.
• The strength of the signal has changed due to season or time of day
• The watch is placed in the reinforced concrete building
• There is a broadcasting station nearby
• Strong enough signal cannot be received due to the position of the watch
The signal used for the local time setting differs from that for the facility testing in China using TEM cell.
* For the local time calibration signal, use the normal mode.
* To check the signal using TEM cell, perform the inspection in the Test Mode.
MANUAL/AUTO Reception7-5-1.
For details of MANUAL and AUTO reception modes, refer to the Operation Guide.
MANUAL Reception
While in Normal Time Keeping mode, hold down
D
for 2 seconds to start receiving signals manually.
Reception OK: The time is adjusted and “GET” appears on the display for 2 minutes.
Reception NG: No time adjustment is made and “ERR” appears on the display for 2 minutes.
* Press
D
to end the manual reception or the reception result display and return to the normal Time
Keeping Mode.
AUTO Reception
Turn on the AUTO Reception setting. When AUTO Reception is turned ON, the calibration signal is
automatically received up to 6 times from midnight through early morning.
(If reception is successful once, the subsequent AUTO reception will not be conducted on the same
day.)
Whether reception was successful may be conrmed with [Last Receiving Date/Time] in the [Last Re-
ception] display.
(The date/time is updated after successful reception.)