— 5 —
Screw
RESET
3. TO REPLACE THE BATTERIES
1) Loosen the screw on the back of the SF-4400/4600B
that holds the battery compartment cover in place,
and remove the cover.
2) Loosen the screw that secures one of the two battery
holders in place and remove the battery holder.
Caution:
Be sure to remove only one battery at a time.
Otherwise, you will lose all data stored in memory.
3) Replace the old battery with a new one, making sure
that the positive (+) side of the new battery is facing up
(so you can see it).
4) Replace the battery holder and secure it by tightening its screw.
• Be sure careful that you do not over tighten the screw.
5) Repeat steps 2) through 4) for the other two batteries.
• Be sure to replace all two batteries. Never mix old batteries with new ones, and be sure to use
CR2032 lithium batteries only.
6) After you replace all two batteries, replace the battery compartment cover and secure it by tightening
its screw.
• Be careful that you do not over tighten the screw.
To Next Page
Loading...
Need help?
General
