BEFORE USING THE CALCULATOR
FOR THE FIRST TIME...
Batteries are not loaded in your calculator at the factory.
Be sure to follow the procedure below to load batteries and adjust the display contrast
before trying to use the calculator for the fi rst time.
1. Remove the battery cover on the back of the calculator.
• While pressing on battery cover at the point marked 1, slide it in the direction of the
arrow in the illustration.
2. Load the batteries that come with the calculator.
• While pressing the – end of a battery against the spring (Figure A), lower its + end into
the compartment (Figure B).
(Figure A)
(Figure B)
3. Check to make sure that the springs are not sticking out to the side and that the
batteries are not sliding out of position.
Batteries loaded correctly.
20070201
To Next Page
Loading...
Need help?
General
