[Type here] [Type here] [Type here]
11 Motor, Bits, and General Information
Because the motor is enclosed, it is important that the guidelines provided in
this instruction manual are strictly observed.
• The motor is serviced by Castle and if service is required please contact the
factory.
• Use dust extraction for clearing sawdust out of your machine case and creating air
flow through the case to aid in cooling the motor.
• The pocket is made with a 5/16” router bit, #B02516 and the pilot hole is made
with a 5/32” drill bit, #B06924.
• Contact our Castle Parts Department at 800-282-8338 for information and pricing
on tooling for The Castle-110, or shop our convenient Web Store for online
ordering. http://store.castleusa.com/
General Safety Rules
WARNING Read all safety warnings and instructions. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious injury. The
term “power tool” all of the warnings listed below refers to your mains-operated
(corded) power tool.
To Next Page
Loading...