• Power factor (average)
• Total energy output (kW/h)
The display will stop scrolling when the operator
presses the power meter key for less than 5 seconds.
The display will show a particular parameter
continuously. Additional power meter functions will
scroll if the power meter key (32) is held for more
than 5 seconds and then released. The additional
functions are shown below.
• Total real power (kW)
• Real power phase A (kW)
• Real power phase B (kW)
• Real power phase C (kW)
• Total apparent power (kVA)
• Total reactive power (KVAR)
• Percentage of rated power (%kW)
• Power factor (average)
• Power factor phase A
• Power factor phase B
• Power factor phase C
• Total energy output (kW/h)
• Total reactive energy output (kVARHr)
Note: All real power values are signed with a “+” or a
“−” . A negative value indicates reverse power.
Note: Real power phase A, B, and C as well as
power factor phase A, B, and C are not shown when
setpoint P032 is set to 1 for delta generator sets.
Note: Total energy output that is greater than
999,999 kW/h will be shown as MW/h in two steps in
order to maintain a resolution of 1 kW/h. The first
step will show MW/h as a whole number up to six
places. The second step will show MW/h as a
decimal to three places. For example: 1,000,001 kW/
h will be shown as 1000 MW/h (first step), followed
by .001 MW/h (second step).
The right side of lower display (31) shows the value
of certain engine parameters. The parameters are
listed below.
• engine oil temperature (optional)
• system battery voltage
• engine hours
• engine speed
• engine oil pressure
• engine coolant temperature
The value for one of these conditions is shown on the
display (31) for two seconds. The display then scrolls
to the value for the next condition. A small pointer
identifies the engine condition that corresponds to
the value that is showing. When the engine meter key
(34) is pressed, the lower display (31) stops scrolling.
The lower display continuously shows one particular
value. The pointer flashes above the value that is
showing on the display. When the engine meter key
(34) is pressed for the second time, the lower display
will return to scrolling.
The relay status indicators are on the bottom of the
lower display (31). When a GSC+ relay is activated,
the corresponding indicator (K1, K2, etc) is shown on
lower display (31). When a relay is not activated, the
corresponding indicator (K1, K2, etc) is not shown.
For a description of the relay functions, see the
Systems Operation, Testing and Adjusting,
RENR2484, “Electronic Modular Control Panel II+
(EMCP II+)”.
Keypad
Illustration 67 g00634183
Keypad Area of the GSC+
(25) Fault shutdown indicator
(26) Fault alarm indicator
(29) Upper display
(30) Alarm codes key
(31) Lower display
(32) Power meter key
(33) AC meter key
(34) Engine meter key
(35) Lamp test key
(36) Exit key
(37) Service mode key
(38) Keypad
SEBU7125-13
57
Operation Section
If Equipped
To Next Page
Loading...