CAT EMCP 4 - 7.9 READING EVENT DATA

Application and Installation Guide EMCP 4 SCADA Data Links
©2013 Caterpillar
All rights reserved. Page 48
F
IGURE 7-5: RELATIONSHIP BETWEEN ANALOG INPUT SENSOR AND MEASURED VALUE
The procedure and approach to reading analog outputs is similar to that of reading analog inputs.
7.9 READING EVENT DATA
The procedure for reading event information via SCADA for the EMCP 4 is the same as for EMCP 3.
Below is an example of Reading Event Information via SCADA on and EMCP 4.
For the purposes of this example, an EMCP 4.2 GSC is being monitored. This module is not connected to
any other EMCP modules. It is configured to SCADA Data Link Slave Address 1, and has the following
events.