HU-25
Set alarm
• Press and the alarm icon will begin
to flash which means the alarm function
has been chosen “0:00” will display.
Press
the " " and " " button to set alarm time.
The time can be adjusted between “0:01~23:59”. Press once on
plus or minus 1, and hold for 3 seconds for quick-adjust. After waiting for 5 seconds to confirm setting, the alarm
icon will be displayed and
the alarm time will be shown on the screen.
You will then see the time counting down on
the screen. When the countdown is finished,
“0:00” will be shown on the screen and it will start buzzing 4 times every
5 seconds. Press any button to stop.
•
If there is no operation for 2 minutes the buzzing will stop. The alarm function is for warning purposes only, it is up
to the user to turn off the oven.
Duration setting
• Press , choose "duration"
function and the icon will begin to flash and “0:00” will display. Press the " "
and "-" button to set the duration time, adjusting range is between “0:01-23:59”. After waiting for 5 seconds to
After waiting for 5 seconds to confirm
setting, the duration time will be set but the time shown on the screen
will be back to the time of day. The duration time will be counting down
internally and when finishing the count
down, the power will turn off directly and the “Duration” icon will flash to
get your attention. Also, “0:00” will be
shown on the screen
and it will start
buzzing 2 times every 5 seconds. Press
any button to stop
.
•
During the cooking duration, by
pressing you can check and change the the cooking duration.
•
After the countdown has stopped, if there is no operation for 2 minutes,
buzzing will stop.
•
If set duration time before end time, end time can only be added, not decreased. (The max time added
can be
after 23h 59m. When end time is longer than duration time + current time, end time can be decreased
by pressing
" ". It will be decreased until end timeequals to duration time + current time
+ 1 minute).
If end time is longer
than duration time + current time,
power will be off, end time icon will display.
When end time equals to duration time + current time, power will be on again, end time icon will turn off.
Time function
•
Press to choose the time function. Time icon will flash, press " " and " " to set time. The range is 24hrs.
Press once to plus or minus 1, hold for 3 seconds for quick-adjust. No operation for 5 seconds, the time of
day
will show, time icon will turn off.
•
If the time setting is changed after setting the alarm, duration and end time,
the alarm will not be changed and
duration and end time will reset.
Lock function
Press lock button
for 3 seconds any
time, the lock function will active and lock icon will display. Press lock button
for 3 seconds again, it will be unlock. The icon turns off. While in lock mode if
any button is pressed it will cause a
buzzing, while the lock icon will flash
for 3 seconds.
Other notification
•
When setting alarm, duration time and
end time, alarm time will display along
end time icons will display.
with alarm, duration,
•
After setting the alarm, duration, and end time, Button 1 can be pressed to
check and change
alarm time,
duration
time, end time and day time.
•
When the duration time and alarm time are set at the same time, if the duration
time is finished after the alarm
time, it will only be buzzing for the alarm time when
the alarm time ends. If the duration time is finished before
the alarm time, it will
also only be buzzing for the alarm time when the alarm time ends.
To Next Page
Loading...
