Catalina 310 - PLUMBING AND INTERIOR (Commissioning); RIGGING AND HARDWARE (Commissioning)

4. __ Check battery switch #1_ #2_ OK.
5. Check battery fluid level.
6. Check battery terminal for tightness.
7. Check battery tie down straps.
PLUMBING AND INTERIOR:
1. No leaks at through hull fittings with seacocks open or closed.
2. Fill all water tanks.
3. Check all water tanks at fittings and vents for leaks.
4. Test all faucets and foot pumps for leaks.
5. Check for leaks at sink drain, sink drains OK.
6. Put water in ice box and check for proper drainage.
7. Check manual bilge pump operation, handle present.
8. Check head by flushing and pumping.
9. Check shower sump drain line.
IO. Check holding tank, pump vent and fitting.
11. Check head and pump handle for leaks.
12. Main hatch no leaks, slides freely, hatch boards fit OK.
13. Cabin windows hose tested for leaks.
14. Anchor locker drains OK, no Leaks.
15. Stove operates OK; check tank, fuel line, burner and oven.
RIGGING AND HARDWARE:
1. Mast stepped.
2. Pin, tape and tune standing rigging
3. Blocks, cars, cleats rigged OK.
4. Test all winches, winch handles present.
5. Boom vang supports boom
6. Check chainplates for leaks (*note 1)
7