COMMISSIONING CHECK LIST
This check list is intended as a guide to aid in the proper delivery and commissioning of a new boat to the
originator purchaser. It may also be useful to review this list each time the boat is recommissioned after
storage.
PRE-LAUNCH CHECK: (before stepping mast)
1. Shaft turns freely by hand, zinc collar installed if required.
2. Check intake hoses and clamps.
3. __ Check all through hull fittings.
4. Drain plugs tight, __ engine, muffler and exhaust line OK.
5. Bottom clean, paint OK.
6. Hull sides clean, gel coat OK.
7. Decks clean, gel coat OK.
8. Interior varnish OK.
9. Cushions, curtains, clean and in place.
10. Lifelines, pelican hooks and pulpits rigged and OK.
11. Spreaders taped at base end, upper shroud and intermediate wired to tip end and
taped or boots installed.
12. Rigging lengths verified with check list in kit.
13. Mast and boom inspected; cotter pins, sheaves, tangs, spreaders, reef lines, outhaul,
OK.
14. Mast lights checked before mast stepped
15. Check overhead for electrical wires which may interfere with the space
required to raise the mast to its full upright position. If there are wires
of any kind anywhere near the boat. Do not raise the mast. Move boat
to any other location away from any wires. Contact with wires can be
fatal.
16. Masthead sheaves lubricated and rotate freely.
ELECTRICAL:
1. Lights operational:
_Running _Cabin _Bow _Anchor _Deck Light
2. Pumps Operational: _Pressure Water _Macerator Pump _Bilge Pump
3. Shore power outlet OK.
6
To Next Page
Loading...
