3
UK
4. The appliance will run a startup routine and then begin ice production.
5. When the cubes reach the ice sensor the appliance will stop production. Production resumes once ice
has been removed.
6. Press the STOP button at any time to halt the ice making process.
Cleaning, Care & Maintenance
• Always switch off and disconnect the power supply before cleaning.
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues. DO
NOT wash the base unit, instead wipe the exterior with a damp cloth.
• A POLAR agent or qualified technician should carry out repairs if required.
• Clean the water filter regularly with a small brush, particularly in hard water areas. The water filter is
located in the pump inlet at the bottom of the water tank, remove by pulling out with fingers.
• If the appliance is to be left unused for longer than 24 hours, loosen the drain screw and drain the
water from the tank.
• The inner removable parts and water tank should be cleaned regularly.
Note: If the water level is too low, the Water Low indicator lights up and the appliance
appliance stops working. Fill the water tank and the appliance will restart automatically.
To Next Page
Loading...