Why is juice leaking from my Catler Kitchen Appliances?
If you notice juice leaking between the rim of the juicer cover and the stainless steel filter basket of your Catler Kitchen Appliance, try juicing at a slower pace by gently pushing the food pusher down. Also, juice fruits and vegetables with high water content, such as tomatoes and watermelon, on the low speed setting.
How to adjust the amount of coffee grind on a Catler Coffee Grinder?
To adjust the amount of coffee grind on your Catler Coffee Grinder: * Press the AMOUNT button to change the grind amount. * Use the ADJUST AMOUNT dial to fine-tune the amount, selecting ‘More or Less’ as needed.
Why Catler Coffee Grinder won't start after pressing start button?
If your Catler Coffee Grinder doesn't start, there could be a few reasons: * It might not be plugged in, so ensure the power cord is properly connected to the outlet. * The grinder could be overheated; unplug it and let it cool down for 20 minutes before trying again. * The bean hopper may not be correctly attached; make sure it is locked into position.
What to do if Catler Coffee Grinder motor is making a loud noise?
If your Catler Coffee Grinder's motor starts but operates with a loud racket noise: * The grinder might be blocked by a foreign object or the chute could be obstructed. Remove the bean hopper and inspect the burrs for any foreign objects. * Moisture may be clogging the grinder. Clean the burr heads and chute. * Allow the burrs to dry thoroughly before re-assembling. You can use a hair dryer to blow air into the grinder inlet to help it dry.
Why can't I lock the bean hopper into position on my Catler Coffee Grinder?
If you're unable to lock the bean hopper into position on your Catler Coffee Grinder, coffee beans might be obstructing the locking device. Remove the bean hopper and clear any coffee beans from the top of the burrs. Then, try re-locking the bean hopper into position.
What to do if the portafilter overfills with coffee from Catler Coffee Grinder?
It is normal for the correct amount of coffee to appear overfilled in your portafilter. Untamped coffee has three times the volume of tamped coffee.
Why Catler Kitchen Appliances will not work when switched “ON”?
The safety locking arm may not be correctly engaged in the vertical operating position with the locking arm located into the two grooves on either side of the juice cover.
Why does the motor stall when juicing with my Catler 800 Kitchen Appliances?
If the motor of your Catler Kitchen Appliance appears to stall while juicing, it could be due to wet pulp building up under the cover from vigorous juicing. Try juicing more slowly by pushing the food pusher down more gently. Also, clean the filter bowl surround, the stainless steel filter, and the juicer cover. Consider selecting the HIGH speed setting instead of LOW.
What to do if my Catler Kitchen Appliance unit will not switch on?
If your Catler Kitchen Appliance unit won't switch on, check the Overload Protection Button located on the bottom of the Motor Base to ensure the safety device hasn't been automatically activated.
What to do if food sticks to the blade of my Catler Blender?
If food sticks to the blade, turn off the blender by pressing the ‘Power’ button on the control panel, then switch it off at the power outlet and unplug the power cord. Wait until the blade stops rotating, then remove the blender lid and take out some of the food with a spatula.
General| Brand | Catler |
|---|---|
| Model | 800 SERIES |
| Category | Kitchen Appliances |
| Language | English |
To Next Page
