What to do if the LCD screen displays ‘RESET’ on my Catler TM 8010?
If your Catler Kettle's LCD screen displays ‘RESET’, it indicates a resettable electronic issue. To resolve this, remove the plug from the wall outlet, wait 5 seconds, and then plug it back in. If the ‘RESET’ message persists, contact the authorized service center.
How to fix the LCD light if it has gone out on my Catler TM 8010 Kettle?
If your Catler Kettle's LCD light has gone out, it may be in standby mode, which activates after 3 minutes of inactivity. To reactivate it, remove and then replace the Glass Jug from the Power Base, or press any button on the Power Base except the HOT WATER|Cancel or TEA|Cancel buttons.
What to do if my Catler TM 8010 will not switch ‘ON’?
If your Catler Kettle will not switch ‘ON’, ensure the power plug is securely inserted into the outlet. Try inserting it into an independent or different outlet. If necessary, reset the circuit breaker. If the issue continues, especially in the event of severe overheating, contact the authorized service center.
How to restore the default settings on a Catler Kettle?
To restore your Catler Kettle's default settings for each function, simultaneously press and hold the AUTO START and KEEP WARM buttons for 2 seconds.
What does it mean when the LCD screen displays ‘ERROR’ on my Catler TM 8010?
If the LCD screen displays ‘ERROR’ on your Catler Kettle, it indicates a non-resettable issue with the appliance. Contact the authorized service center for assistance.
Why doesn’t the ‘BASKET CYCLE’ feature work on my Catler TM 8010?
The 'BASKET CYCLE' feature or BASKET button on your Catler Kettle is only operational during brewing cycles that are under 10 minutes. The Tea Basket cannot be lowered during the heating up phase of normal operation.
How to adjust tea strength with my Catler TM 8010?
Tea taste is a personal preference. For stronger tasting tea with your Catler Kettle, increase the amount of tea or brew time. For a weaker tasting tea, decrease the amount of tea or brew time.
Why is there a rattling noise inside the glass jug of my Catler TM 8010?
The rattling noise inside the Glass Jug of your Catler Kettle is normal. It comes from the magnet located inside the jug post and may be heard when the Tea Basket is not attached.
Essential safety precautions for operating the automatic tea maker.
Steps for initial setup and cleaning of the tea maker.
Instructions for using the appliance to brew tea.
Choosing tea type, strength, and brew time for optimal taste.
Using the tea maker to heat water to custom temperatures.
Instructions for cleaning the jug lid and integrated scale filter.
To Next Page
General