Technical instructions
ZELIA VP v1.1EN
The cell of the Zelia VP must not be splashed with large amounts of water on a regular basis.
When technical blocks are integrated and/or buried, we recommend you do not install it under
a skimmer, these regularly overflow when people are in the pool.
The Zélia VP cell is designed to be installed on a horizontal pipe only, with the control interface
on top. It should not be installed on a vertical pipe.
1. Packaged content
• 1 ZELIA VP power supply box
• 1 ZELIA VP cell
• 1 set of 2 1.5" union fittings for tubes with a 50mm diameter
• 1 bag including
– 3 screws and 3 attachment pegs for the power supply box
– 2 seals for the union fittings
2. Technical features
Power supply 230V ~ AC 50/60Hz
Power consumed 100W
Maximum volume treated* 100m³ *
Recommended salt rate 2 to 4 g/l (ideally 3 g/l)
Production of chlorine up to 20g/h
Cleaning of cell Automatic by reversal of polarity
Maximum pressure (cell) 3 bars
Maximum rate (cell) 15 m3/h
Protection index
Power supply: IP-44
Cell: IP-55
Overall dimensions
Power supply: 220 x 171 x 68mm
Cell: 192 x 138 x 134mm
Full box: 383 x 230 x 164mm
Installation
Power supply : Wall attachment (3 screws/pegs provided)
Cell: On PVC tubes with a 50mm diameter (1.5" union fittings
provided)
Poids
Power supply: 1 kg / Cell: 1,2 kg
Full box: 2,9 kg
* given Volume for a pool water at 25°c, with a measured pH at 7.0, stalilizer at 40ppm, with no plant residues in water and
an appropriate daily filtration time.
2
To Next Page
