03
CCELL User guide
Charging
01. Screw in the 510 thread end of the Power Supply
into the 510 thread USB charging adapter.
02. Plug USB into active port or wall adapter.
03. Halo lights up, indicating the device is charging.
Halo remains lit during charging.
04. Halo ashes 20 times and turns off when fully
charged.
05. Charging light stays red, even when fully
charged. Once device is fully charged the light
on the end of the battery will pulse 10 times and
then turn off, indicating full charge. If device is
plugged into an active USB port and the halo is
not lit, the device is fully charged.
This device is equipped with overcharge
protection, allowing it to stay plugged
in until used.
To Next Page
Loading...
