Enter Master Password (1234) + #
Keep Pressing 2 to select “Auto ARM/DISARM”
Press #
Press 0 for Sunday
1 for Monday
2 for Tuesday
3 for Wednesday
4 for Thursday
5 for Friday
6 for Saturday
7 for All Days
Press “UP” or DOWN” to select Grp 1, Grp 2 or Grp 3.
Press 4 to make Grp = ON / OFF
BACK SPACE + HH + MM + # + hh + mm + # + Quick Exit
Where, HH = ARM Time: Hours in 24 hrs mode & MM = Minutes
hh = DISARM Time: Hours in 24 hrs mode & mm = Minutes
Default: In default the system is not in Auto Arm / Disarm mode.
Note: To operate the system with separate Day wise timings, keep all the 3 Groups of “All Days” = OFF.
: User can use all the 3 time groups by entering the same DISARM time but keeping the ARM time different or
Vice Versa. Example: If system is to be operated with following changing time for all days:
First ARM Time = 11 PM
DISARM Time = 9 AM
Second ARM Time = 1PM
DISARM Time = 2PM
Then programming would be:
“SET”
Master Password (1234) + #
Keep Pressing 2 to select “Auto ARM/DISARM”
Press #
Press 7
Press “UP” or DOWN” & select Grp 1 + 4
Back Space
2300 + #
0900 + #
Press “UP” Key (Grp 2 will appear) + 4
Back Space
1300 + #
1400 + #
Quick Exit
: To ARM the system for the whole day, enter ARM Time = 0000 and DISARM time = 2359
: If all the 3 Time Groups of a day are = OFF then the previous day’s last status (Armed / Disarmed) shall continue.
: Example of Day wise operation
If system is to be operated with following time:
From Monday to Saturday
ARM Time = 10 PM
DISARM Time = 9 AM
On Sunday
All day ARM
i.e., ARM Time = 0000 Hours
DISARM Time = 2359 Hours
The programming would be:
“SET” + Master Password (1234) + #
Keep Pressing 2 to select “Auto ARM/DISARM”
Press #
Select the Day 1 (for Monday)
Press “UP” or DOWN” & select Grp 1 + 4 + Back Space
2200 + #
0900 + #
Quick Exit
Repeat the above for Tuesday + Wednesday + Thursday + Friday + Saturday
Now for Sunday all the 3 Time Groups should be = OFF
: If the system is working in Auto ARM / DISARM mode & the Battery of the main unit goes low then the system will
not ARM. At the time of ARMING it will dial out & give message =Zone 99 Battery Low. It will not sound the siren
in this case. The same would happen if any of the Sensor is Open at the time of Auto ARMING.
The message given would be = Wired / Wireless Sensor + Zone / ID number.
Holidays entry
Up to 10 holidays can be entered in the system. On those days the system will continue in the previous day’s status.
Entry of day:
Press “SET”
To Next Page
Loading...