25
Clean Programme
To keep the appliance operating at peak efficiency over time, it
has a “Clean” programme for regular cleaning of the drying circuit
to remove any fluff deposits.
1. After a given number of drying cycles, the “Clean” symbol
lights up on the display to warn that this programme needs
to be run. The warning light remains on until the “Clean”
programme is carried out. The light goes out at the end of
the programme.
2. To perform the “Clean” programme, proceed as follows:
a. Make sure that the drum is completely empty and
close the door.
b. Turn the knob to the “Clean” programme (see
programmes table for the exact position on the
knob).
c. Press the “START/PAUSE” button.
The “Clean” programme can also be carried out even if the light
on the display is not on.
Clean programme symbol
To Next Page
Loading...
