CDA ci971

36
Problem
Suggested Checks
Appliance does not spin
Anti-imbalance safety device tripped
because laundry not evenly distributed in
drum. If laundry is still wet at end of cycle,
rearrange it in the drum by hand and repeat
spin programme only “Start/Pause” button
has been pressed
Emptying water from drum In the event of a power blackout, or
appliance failure, water can be removed
from the drum by using the emergency
procedure
Laundry not properly spun
Large items squeezed up and not evenly
distributed in drum. Always wash a mix of
large and small items together
Traces of detergent on
laundry
Many phosphate-free detergents contain
substances with low water solubility.
Select Rinse programme or brush the
laundry
Laundry not dried
Check that:
- water tap is turned on
- load of laundry is not excessive
- drying time is long enough
- appropriate drying time selected.
If the appliance still does not dry the laundry,
call the Service Centre to have the fan and
drying ducts cleaned to remove any fluff
deposits.
Washing results
unsatisfactory
-
Probably too little detergent or unsuitable
detergent used
- Difficult stains not dealt with before washing
- Correct temperature not set
- Basket overloaded