MANUAL LOADER CHAPTER 6
6-61
IMPORTANT
The connector on single transducer cables contains the EEPROM calibration memory
chip. Never attempt to remove the connector from the transducer.
B- Hand Crank
Turn hand crank on the loader to apply torque. 2000 ft lbs of torque are generated with only 8 ft-
lbs of manual torque applied.
C- Reaction Block
The reaction block is positioned so that the reaction pins straddle the wrench handle at the hand
hold position specified on the wrench.
D- Linear Bearings
May be slipped over the reaction pins to reduce friction when testing very small or high resolution
electronic wrenches.
E- Reaction Pins
Hold the reaction block in place.
IMPORTANT
Adjustable stops on the reaction pins may be raised or lowered to level the wrench prior to
loading. Do not place a second stop above the wrench handle. It is normal for the wrench
handle to rise as it levels itself under load.
F- Drive Adaptor
A drive adaptor couples the wrench to the transducer. Low torque SURETEST series transducers
use an internal-internal drive adaptor and high torque SURETEST transducers may use an
adaptor/reducer.
G- Transducer (Accessory)
The loader accepts all SURETEST series single transducers directly. An optional 2000-400-02 4-
in-1 transducer can be mounted using a 2000-500-02 adaptor kit. For more information, refer to
Appendix A–Accessories.
To Next Page
Loading...
