Need help?Do you have a question about the Cecilware FTC-3-N and is the answer not in the manual?
Guidelines for operating the unit in specific environmental conditions to prevent damage.
Instructions for unpacking the unit and its included components.
Detailed instructions for connecting the water supply to the brewer.
Adherence to plumbing and food safety regulations.
Step-by-step guide for initial setup and power-on.
Chart detailing hot water, cold water, and delay times for different models.
Important safety warnings regarding hot water and tea dispensing.
Procedure for conducting a brew cycle, including funnel and tea bag placement.
Warning to unplug the brewer before performing any service.
Procedure for adjusting the hot water dispensing time and volume.
Procedure for adjusting the cold water dispensing time for dilution.
Instructions to restore timer settings to factory defaults.
How to adjust the delay timer for proper brewing sequence.
Specific adjustments for FTC-10 model.
Explains the function and flow rate of the dual water inlet valve.
Details the fixed flow rates for different models.
Procedure to increase or decrease the brewing water temperature.
Tests to verify the functionality of the water inlet valve.
Checks the water level probe for proper operation.
Tests for the water level control board's output and connections.
Tests the dual probe system for water level detection.
Verifies the dual probe liquid level controller's power input and output.
Steps to prepare a sanitizing solution using bleach.
Instructions for sanitizing parts and rinsing.
Mandatory daily cleaning for stainless steel surfaces.
Recommended cleaners and brushes for stainless steel.
Diagnoses and remedies for issues related to brewed tea quality.
Troubleshooting for no water, dripping, or continuous water flow.
Addresses issues where the water is not heating up in the tank.
Diagrams and parts list for tank assemblies of specific models.
Diagrams and parts list for the FTC-10-N tank assembly.
Dimensional overview of the FTC-3-N tea dispenser.
Dimensional overview of the FTC-3.5-N tea dispenser.
Dimensional overview of the FTC-5-N tea dispenser.
Dimensional overview of the FTC-10-N tea dispenser.
General| Model | FTC-3-N |
|---|---|
| Capacity | 3 Gallons |
| Material | Stainless Steel |
| Warmer | Yes |
| Type | Coffee Brewer |
| Category | Coffee |
| Voltage | 120V |
| Phase | Single |
| Water Source | Plumbed |
To Next Page