3. OPERATION
1. Select the attachment that best fits your needs.
2. Fix the desired attachment
to the top part of the device body.
- To remove the shaving head or any other attachment
assembled, hold the shaver body with one hand and slightly
turn it counterclockwise with the other hand.
- To assemble a different one, insert the attachment into the
shaver’s slot, then turn it slightly clockwise to fix it in place.
- To assemble the beard guide comb attachment, insert the
shaving head inside the guide comb and lock the
attachment fixing tab in place.
- The guide comb attachment includes a length-adjustment
knob. Length can be adjusted from 0.5 mm to 10 mm and
adapted to the desired haircut.
- To remove the guide-comb attachment, pull the back part
off the device until the fixing tab is released, then slide the
comb off the blade.
3. Slide the switch upwards to turn the device on and slide it
downwards to tu
rn it off.
Note
The length of the cut may vary depending on the trimming angle.
Start with a longer guide-comb setting and progressively
shorten the cutting length as the hair is cut.
BAMBA PRECISIONCARE 5IN1
50
ENGLISH
To Next Page
Loading...
