cecotec BIGDRY 10000 EXPERT CONNECTED - Fan Mode Operation; Defrost Functionality; Compressor Protection Delay; Wi-Fi Setup and Connection

BIGDRY 10000 EXPERT CONNECTED 59
ENGLISH
Fan mode:
- The compressor does not work.
- The fan has two working modes: high speed and low speed.
- The humidity adjustment icon cannot be pressed while in fan mode.
Protection against full tank:
- When the full tank indicator lights up for 3 seconds, the device stops working and all
air outlets are switched o. The “FULL” indicator light comes on and the device beeps 15
times. Press any icon and the noise will stop immediately.
- When the “full tank” warning disappears, the dehumidier will resume operation (the
device will rst remain in protection mode for 3 minutes).
Defrost function:
- When the dehumidier enters defrost mode, the “DEF” indicator light comes on. The
compressor then switches o and starts to remove the accumulated ice and frost in the
fan for running at full power.
- When the ambient temperature is less than or equal to 16 °C, the device does not detect
the compressor temperature. Depending on the ambient temperature, the following
happens:
- The device will stop working when the ambient temperature is below 5 °C.
- In places where the ambient temperature is between 5 and 12 °C, the device will start for
30 minutes and the defrost mode will stop for 10 minutes.
- In places where the ambient temperature is between 12 and 16 °C, the device will start for
45 minutes and the defrost mode will stop for 10 minutes.
- When the ambient temperature is above 16 °C, the device will detect the temperature of
the compressor, and perform the process based on this as follows:
- After 30 minutes of operation, the compressor temperature will be detected. If the
compressor temperature is below or equal to 1 ºC, the defrost process will stop for 10
minutes.
Compressor protection delay:
- These delays prevent continuous compressor starts and stops due to sudden
temperature changes.
- If the compressor is switched o, it can be switched on again after an interval of at least
3 minutes.
Wi-Fi:
- Press and hold the Wi-Fi icon for 5 seconds to enter the default Wi-Fi setup mode.
- Wi-Fi light: o indicates that the dehumidier is not connected to Wi-Fi; long light
indicates that the dehumidier has successfully connected.
- All these functions related to the dehumidier can be congured via the App on your
mobile phone.