Pipe-work shall be protected from physical damage and shall
not be installed in an unventilated space, if that space is smaller
than 4 m².
Do not use means to accelerate the defrosting process or to
clean, other than those recommended by Cecotec.
This appliance cannot be used by children or persons with
reduced physical, sensory or mental capabilities or lack of
experience and knowledge. Supervise young children to make
sure that they do not play with the appliance.
Instructions on gas
R-290 (propane) is ammable and heavier than air.
It collects rst in low areas but can be circulated by the fans.
If propane gas is present or even suspected, do not allow
untrained personnel to attempt to nd the cause.
The propane gas used in the unit has no odour.
The lack of smell does not indicate a lack of escaped gas.
If a leak is detected, immediately evacuate all persons from the
store, ventilate the room and contact the local re department
to advise them that a propane leak has occurred.
Keep any required ventilation openings clear of obstruction.
Do not let any persons back into the room until the qualied
service technician has arrived and that technician advises that
it is safe to return to the store.
No open ames, cigarettes or other possible sources of ignition
should be used inside or in the vicinity of the units.
Component parts are designed for propane and non-incentive
and non-sparking. Component parts shall only be replaced
with identical repair parts.
Failure to abide the before instructions could result in an
explosion, death, injury and property damage.
1. PARTS AND COMPONENTS
Fig. 1
1. Control panel
2. Air outlet
3. Front housing
4. Casters
5. Top
6. Air lter
7. Back housing
8. Continuous drainage
9. Water tank
2. BEFORE USE
Take the product out of the box and remove all packaging material.
Make sure all parts and components are included and in good conditions. If any visible signs
of damage are observed, contact the Technical Support Service immediately.
When installing the device, ensure a minimum safety distance of 20 cm to each of its sides.
3. PRODUCT ASSEMBLY
Place the unit on a rm, level surface in an area with at least 30 cm of free space around it to
allow for proper air circulation.
Install the unit in rooms bigger than 4 m².
Never install the unit where it could be subject to:
Heat sources such as radiators, heat registers, stoves or other products that products that
produce heat.
In an area where oil or water may be splashed.
Direct sunlight.
Mechanical vibration or shock.
Excessive dust.
Lack of ventilation, such as cabinet or bookcase.
Uneven surface.
Note: If tipped more than 45°, allow the unit to set upright for at least 24 hours before turning
it on.
To Next Page
Loading...
Need help?
General
