BIGDRY 10000 EXPERT CONNECTED60
ENGLISH
Water draining
When the water tank is full, the full-tank indicator light will turn on, the appliance will
automatically stop operation, and it will beep 15 times to alert the user that the tank needs to
be emptied.
Emptying the device
1. Gently press both parts of the tank with your hands and carefully pull the tank outwards
to remove it. Fig.3
2. Empty water inside the tank. Fig 4.
WARNING
- Do not remove the oat from the tank; otherwise, the sensor will not be able to detect the
water level, and will not be able to operate normally. Fig. 5
- If the water tank is dirty, wash it with cold or lukewarm water. Do not use detergent,
scouring pads, chemically treated cloths, petrol, benzene, alcohol, thinner, or other
solvents, as these can damage the tank and cause water leakage.
- To install the tank back in place, push it rmly into place with both hands. If the tank is not
properly installed, the full-tank indicator will turn on and the appliance will not work. Fig.
6
Continuous water drainage
The unit features a continuous-drainage port. Use a plastic pipe (with an inner diameter of 10
mm), insert it into drain hole, reach out from side of water tank. By installing the tank in place,
and straightening the pipe, you can drain the water from the dehumidier through the drain
outlet. Fig. 7
4. CLEANING AND MAINTENANCE
Cleaning the housing
Clean it with a soft, wet cloth.
Cleaning the lter
1. Remove the lter. Fig. 8
2. Clean the lter.
Use a vacuum cleaner to carefully remove dust from the lter surface. In case the lter is
particularly dirty, clean it using warm water and a non-abrasive detergent. Dry thoroughly.
Fig. 9
3. Place the ler.
Replace the lter in the device by snapping the two hooks back into place. Fig. 10