BREEZECARE 3500 WARMBREEZECARE 3500 WARM
4039
The light indicators
is on when switched
on, but no mist
comes out
Humidifie is not turned on.
Press the power button to turn
it on.
The target humidity is reached.
Increase the target humidity or
change mode.
Water shortage
indicator is on
No water in the tank.
Refil the water tank and wait at
least 1 minute.
Water level is low.
The water level required
has not yet reached the
vaporisation compartment.
Wait at least 1 minute.
The water tank isn’t well
positioned.
Check the positioning of tank on
the base.
The humidifie isn’t on a flat
surface.
Check the positioning of the
humidifie .
The % RH of the room is over
90 %.
Wait until the % RH gets lower.
Humidifie produces
an unusual smell
Humidifie is new.
Take out water tank, open cover,
let it stay 12 hours in cool position.
Dirty water or water sitting
too long.
Clean water tank, fil with clear
water.
Residual smell from diffusing
aroma oil on the aroma cotton.
Remove the aroma cotton, rinse
it under clean water and allow it
to dry.
Humidifie makes
a loud or unusual
sound
Resonant in water tank when
water is too low.
Fill water into water tank.
Humidifie is on an unstable
surface.
Move the humidifie to a stable
flat surfa e.
Water tank is positioned
incorrectly.
Turn off and unplugthe humidifie ,
then align the water tank cover
with its respective opening in the
inner chamber.
Humidifie is malfunctioning.
Stop using the device immediately
and contact the Technical Support
Service of Cecotec.
The humidification
capacity is too low
There is natural or artificia
air replacement in the room
which interfere the increase
of %RH.
Check if doors and windows are
closed.
Check if there is no air
conditioning working in the room.
The air inlet grids and nozzle
could be blocked.
Remove any blocking items from
the grids and the nozzle.
Too much scale in the water
basin.
Clean transducer.
The humidity selected rate is
too low.
Increase mist output speed.
Increase humidity setting rate.
Water is too dirty or water kept
too long in the tank.
Clean water tank, change to fresh
clear water.
The ambient
humidity is too high
Humidifie is working in
Continuous mode.
Change the mode.
The humidity target is too high. Select a lower %RH target.
Room is not well-ventilated
Open a window to ensure proper
air fl w for the humidifie or
move the humidifie to a better
ventilated room.
Excess water tank has spilled
while fillingthe water tank or
replacing the water tank back
onto the base.
Wipe off e cess water from the
top and bottom of the base before
replacing the water tank.
There is
condensation in the
room
The room temperature is too
low.
Heat the room up.
The mist suddenly
stops coming out
Programmed timer period has
run out.
Turn humidifie on.
The water shortage indicator
is on.
Refil water tank.
The target humidity level is
reached.
To Next Page
