BREEZECARE 3500 WARMBREEZECARE 3500 WARM
3837
During operation, hold down the humidity symbol for 2 seconds to turn the blue light
indicator and the display on. Touch the symbol again to turn it o. After 15 seconds of no
operation, the light indicators and display will turn o.
Timer
There are 12 timer settings: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,11, 12 hours.
Press the Timer symbol repeatedly to select the desired operating time.
Press the Timer symbol until “-- --” is displayed or hold down the Timer symbol twice to
cancel the timer.
Once the timer is set, do not touch any button and setting will be automatically saved after 5
seconds. After 1 minute, the display will show the current humidity.
The display will show the remaining time every hour.
Warm water mist
Press the Warm mist button to turn the warm mist function on and o. The warm mist
function indicator will light up.
Note: This function is not available when there is no water in the tank or when it is running
under a non-humidifying mode.
Auto shut-off ystem
When the tank runs out of water, the device will automatically stop operating. The red light
indicator will turn on.
Refil the water tank, and the device will continue operating with the previous settings. If the
tank is not refilled,the device will turn off afte 5 minutes.
Aroma box
Press on the aroma box to remove it from the base and pour aroma oil into the aroma box.
Fig 3.
Warnings:
Never run the humidifie when there is no water in water the tank and water basin.
Only pour aroma oil into the aroma cotton. Do not pour any liquid other than clean water into
the water tank or water base.
5.
CLEANING AND MAINTENANCE
Use a soft, damp cloth to clean the surface of the device.
Do not use detergent, scouring pads, chemically treated cloths, gasoline, benzene, alcohol,
thinner, or other solvents, as these can scratch and damage the tank and cause water
leakage.
Do not immerse the product in water or any other liquid.
If scale is built up due to the use of hard water, it is recommended to:
Use cold boiled water or distilled water.
Clean the transducer, water tank and basin humidifie every week.
Change the water in water tank more often to keep it fresh.
Make sure to pour out water from the water tank and dry the water basin before you store it
unused for a long time.
Clean the whole humidifie and make sure that all parts of the humidifie are dried completely
if it is supposed to be leaved unused for a long time.
Cleaning the transducer
Clean with clean water or citric acid if there is scale in it.
Brush offthe scale from the surface.
Rinse the transducer with clean water.
Cleaning the humidifie basin
Clean the water basin with soft cloth or use citric acid if there is scale in it.
If there is scale covering the security switch, drop citric acid for 2-5 mins on the scale and
clean it out with the brush.
Rinse the water basin with clean water.
Cleaning the ceramic fi ter
Clean the ceramic fi ter after using 1000L of water regularly. (This is approximate and
depends on water quality).
If the ceramic ball is dirty, it needs to be cleaned more frequently.
It can be dipped in vinegar about 5 minutes. Then rinse it with clean water.
Place the fi ter under the sun for 4~6 hours.
6. TROUBLESHOOTING
Trouble Possible cause Solution
The light indicator is
offwhen switched
on
The humidifie is not plugged
in.
Plug the humidifie into a powered
electrical socket.
Power cord is damaged.
Stop using the device immediately
and contact the Technical Support
Service of Cecotec.
Humidifie is defective or
malfunctioning.
To Next Page
Loading...
