cecotec Conga 5090 Cyclone - Cleaning Other Components

ENGLISH
42
SILICONE BRUSH
To clean the silicone brush, follow the instructions on the
previous section to remove it from the robot and wash it
with water and soap. Dry it thoroughly before installing it
back to ensure it operates efciently.
CEPILLO JALISCO (BRUSH)
To clean the Jalisco brush, follow the previous section’s
steps to take it out and clean it with water. Dry it thoroughly
before installing it back to ensure it operates efciently.
DUST TANK
1. Take out the dust tank.
2. Open dust tank and empty it.
3. Use the cleaning brush to clean the inside of the dust tank.
4. Install the dust tank back in the robot.
421
WET & DRY TANK
1. Take out the Wet & dry tank.
2. Separate the dust compartment from the rest of the tank.
3. Open dust compartment and empty it.
1 2 3
4. Use the cleaning brush to clean the dust compartment.
5. Assemble the dust compartment in the Wet & dry tank.
6. Install the Wet & dry tank back in the robot.